Mills for plastics
The equipment is designed for crushing plastic waste, especially thermoplastics. The knife mill and pneumatic transport fan are started with the buttons installed in the operating box. After start-up, the waste is transferred to knife mill through the chimney. In the mill the waste is crushed and falls through the sieve into the chute in the rack. In the chute permanent magnets are installed to catch the ferromagnetic pieces from the chute by compressed air generated by the fan. Cut waste is transported to a separator, where it is dedusted and loaded into a suspended bag. Dusty air is directed to the cyclone, where it is cleaned and directed outside, the dust falls into a suspended bag. UR-600 mills for plastics are also equipped with screw conveyor.
Młyn UR 250
Młyn UR 250
UR-250 Mills for plastics TECHNICAL CHARACTERISTICS
Propeller diameter – 250 mm
Propeller length – 500 mm
Inlet to cutting mill – 500 x 200 mm
Performance depending on the type of crushed waste and sieve mesh size – up to 200 kg/h
Motor driver power – 7,5 kW
Motor power of dust collector system – 0,18 kW
The degree of fragmentation – 3-12 mm
Device size (with operating box) – 1700x1120x1670 mm
Device weight – 700 kg
Dedusted cut parts – contain less than 2% dust
Młyn UR 400
Młyn UR 400
UR-400 – UR-400 Mills for plastics TECHNICAL CHARACTERISTICS
Propeller diameter – 400 mm
Propeller length 2×250-500 – 500 mm
Inlet to knife mill – 490 x 350 mm
Performance depending on the type of crushed waste and sieve mesh size – up to 800 kg/h
Mill driver: motor power 18,5 KW at the customers request 22 KW
Devices weight -1340 kg
Size: width -1840 mm length -1660 mm height – 2280 mm
The degree of fragmentation: (maximum particle size depending on the size of the sieve mesh) – 3 – 25 mm
Dedusted cut parts – contain less than 2% dust
Młyn UR 600
Młyn UR 600
UR-600 Mills for plastics TECHNICAL CHARACTERISTICS
Propeller diameter – 600 mm
Propeller length – 800 mm
Inlet to knife mill – 700 x 450 mm
Performance depending on the type of crushed waste and sieve mesh size – up to 1200 kg/h
Cutting mill driver – motor – 45 KW at the customers request 55KW
Packaging systems driver: – fan motor – 5,5 kW
Number of propeller blades – 4 pairs / double function, diagonal set/ Number of fixed knives – 3 +1 pieces
The degree of fragmentation – 6 – 30 mm / cut parts dimensions /
Maximum capacity is achieved by grinding waste of PP and PS with a sieve of 20 mm for 1 hour of continuous operation and maximum power equipment in waste.